It’s time to get your entries ready for the LAG Pre-qualifying Show. IT WILL BE HELD MARCH 1st TO MARCH 31.st.
If you are a new member of the Guild and your membership dues are paid, you are welcome to enter this show.
ALL ART WORK MUST BE DELIVERED March 1 FROM 10-11:30 AM. You may bring your work at the same time as the exchange date on Feb. 29. If you have to bring your work earlier, please have it marked that it is an entry for the ANAC show. The ANAC state requirements are listed below.
Please send in your Pre-registration sheets as soon as possible. We need to know the number of entries ahead of time so that we will know the amount of wall space we need at the gallery.
ANAC EXHIBT RULES (REVISED FEB. 19, 2012)
READ RULES OVER CAREFULLY TO INSURE YOUR WORK WILL BE SEEN BY THE JUDGE.
1. ENTRIES:
Two-dimensional work shall not exceed 40 inches wide by 40 inches high. This includes the frame. All work must be properly framed or have exposed perimeter edges finished consistent with the art piece. Work must be ready for hanging (use screw eyes and wire, NO SAWTOOTHS) and must be framed using Plexiglas (except pastels). Gallery wrapped canvas is acceptable without a frame, but the canvas edges must be painted around the sides. Edges must be lapped and ALL STAPLES MUST BE COVERED. If chosen for the travel show, ANAC will provide the carry case. ****Any two dimensional artwork which has glass as a medium must provide a travel container with the same requirements as three dimensional art work.
Three-dimensional work (free standing or relief on the wall) shall not exceed 36” in any direction. It shall not exceed 75 pound in weight including the weight of the packing box. A travel container of quality construction in proportion to your artwork is required even if the piece hangs on the wall. If upon inspection the exhibit board votes that the container is not of sufficient construction to withstand the rigors of travel the piece will NOT BE ELIGIBLE FOR JUDGING. All 3-D shipping containers MUST REMAIN with the artwork until the judging is completed. All 3-d artists must provide a pedestal (if needed) for the conference show only.
- A maximum of two art pieces may be exhibited per member.
- Work must have been completed in the last two years.
- No work can be previously shown at ANAC. This includes closely copied images from any of your previous ANAC submitted work.
- All work must be PROPERLY IDENTIFIED ON THE ARTWORK.
IF YOU ARE ONE OF THE MEMBERS WHO’S ART WORK WILL BE GOING ON TO THE STATE ANAC SHOW, you will need to pay an additional ANAC fee and travel fee of $7.00 per piece.